¼″ Bead Extrudes Approximately 86 ft.
3⁄8″ Bead Extrudes Approximately 38 ft.
Utility Knife
Caulking Gun
Tool to Puncture Inner Seal of Cartridge
Wear Gloves
The temperature of the adhesive, the surfaces and the working area must be above 40°F (4°C) and below 100°F (38°C). For best performance, apply adhesive at 70°F (21°C).
Ensure surfaces to be bonded are clean, dry, structurally sound and free of dust, grease, oil, snow, ice, standing water or other contaminants.
To increase adhesion, sand glossy surfaces to a dull finish.
Pre-fit all materials prior to applying product.
Cut off tip of cartridge at a 45° angle to desired bead size.
Puncture inside seal of cartridge.
Store in a cool, dry location at room temperature.
Take unwanted product to an approved household hazardous waste transfer facility.
Hardened material may be disposed of with trash.
CAUTION! CONTAINS ETHYLENE GLYCOL and Crystalline Silica.
Avoid eye contact.
Do not take internally.
Use with adequate ventilation.
KEEP OUT OF REACH OF CHILDREN.
Disclaimer
The information and recommednations contained herein are based on our research and are believed to be accurate, but no warranty, express or implied, is made or should be inferred. Purchasers should test the products to determine acceptable quality and suitability for their own intended use. Nothing contained herein shall be construed to imply the nonexistence of any relevant patents or to constitute a permission, inducement or recommendation to practice any invention covered by any patent, without authority from the owner of the patent.